| Mode | Description | |
| 0x00 | Standard | In this mode the Smart Driver enables and expects there to be emergency (DT1) and the second LED channel for TC colour control (DT8). |
| 0x80 | Automatic | In this mode the Smart Driver goes into an automatic detection mode where the ECG will detect if it has an emergency kit connected (DT1) and if there is a second LED channel connected for TC colour control (DT8). |
| 0x90 | Custom Current Mode | In this mode the Smart Driver acts the same as Automatic mode, but the LEDs will be driven at the custom-configured constant current (regardless of jumper selection). |
| 0xA0 | Dual Led Mode | In this mode the Smart Driver operates as a DT6 driver where both LED outputs are driven without DT8 support. |
| 0xB0 | Secondary Led Mode | In this mode the Smart Driver will not drive either of its LED outputs (DT6 and DT8), and instead drives the emergency ports led only (DT1) |
| 0xC0 | Type C Emergency Mode | In this mode the Smart Driver will support DT1 as a Type C emergency device. |
| 0x91 | External Emergency Mode |
In this mode, the Smart Driver will act in the following way See Standalone Mode for more information.) |
| 0x92 | Dual Control Mode (KNX Compatibility Mode) |
In this mode, the Smart Driver will act in the following way allowing two control systems ( One wired and one wireless) to connect to a smart driver and perform different functions.
|
| 0x93 | DT1 Standalone Wireless Mode | In this mode, the Smart Driver will act in the following way - The switch input will adjust the standard light (ON /OFF) - DT1 will be accessible over the Wired DALI or wireless network. - A plug-in sensor and switch will work in networked standalone mode allowing multiple devices to be controlled using standalone mode over the wireless network. For example, if you have an emergency control system, it can do the emergency testing while the sensor and switch inputs can be used to control the lighting using zencontrol standalone mode. |
| 0x94 | DT8 Channel Selection Mode | In this mode, the Smart Driver acts the same as Automatic Mode with the exception that DT8 is supported. - Two different LED banks can be connected, one to each LED output. - Only One LED strip will turn on at any one time - Using Tc colour control ( DT8) the channel outputs can be changed. - Whichever output is the dominant channel will be turned on, while the other will be turned off. ( ie if the colour is warmer one LED will be on, if cooler there other LED will turn on.) example, if you have a batten with a white lamp and a blue lamp, using the TC control you can choose when the blue lamp is on and when the white lamp is on. They cannot be on at the same time. |
| 0x95 | Standalone Wireless Mode | In this mode, the Smart Driver functions the same as Automatic Mode, but additionally enables networked standalone mode. |
Comments
0 comments
Article is closed for comments.