When using the 3rd party UDP or RS232 interface it is possible to send an inhibit command to the control system that disables actions based on sensor stimuli for the duration specified.
This can be set from 1s to 18.2Hrs
Inhibit mode can be cancelled by sending a time of 0s
The functionality is described in the Ethernet UDP application note found on Third party interface
Example usage:
An Audio visual system may wish to take control of the lighting of a particular room for a period of time without interference from the zencontrol control system. The inhibit command will prevent sensor actions for the period of time desired.
Note: This is not the same as the DALI emergency DT1 Inhibit command
Comments
0 comments
Article is closed for comments.