How to setup zc-ss-rot RGB control on a zencontrol controller

The zc-ss-rot can be setup to control RGB devices using the zencontrol Standalone system while on a zencontrol control system. In this mode the zc-ss-rot is capable of sending IEC 62386-209 (DALI Device Type 8) lighting commands to control the colour of a target on the same DALI bus as the zc-ss-rot (remote targets using the zencontrol cloud is not supported). 

1. Add all devices to the zencontrol control system and allow the devices to scan into the zencontrol cloud.
   
2. Using zencontrol Connect, connect to the zc-ss-rot under the Standalone mode > Smart rotary menu. If the device does not appear, restart Bluetooth discovery by power-cycling the device.
3. Set the App controller mode to the bus type that the device will be operating on; Wired only, Wireless only, or Wired + Wireless. DO NOT CHANGE CONNECTIVITY MODE as this will disable the connectivity method entirely.
   
4. Set the ECD operating mode to Standalone RGB Dimmer.
   
5. Under the menu Smart Settings setup your target. Targets may be ECG groups or Broadcast. You must keep the option All devices share the same target selected so that all actions on the zc-ss-rot will have the same target.
   
6. Press the save button in the bottom right of the display. If this process has taken too long you may need to restart Bluetooth by power-cycling the device again if you experience Bluetooth connection issues.
7. On the zencontrol Cloud ensure the lights you want to control are in the correct target as configured.