Zen switches can be manually configured via eDali (25 bit) commands. This type of command is available using Tridonic SCI on products such as the master configurator. Zencontrol Control Systems manage configuration without the need for the user to be aware of this command scheme.
Each eDali command is of the form 0xBE | CONTROL DEVICE Dali Address (in dali address format) | opcode
Generally, the user will be putting some data into DTR0, LED index into DTR1 (if multi led) and then sending a single edali command from the commands below (no repeat necessary).
For example, to instruct the switch at control device address 1 to set dtr0 as primary target, one would set DTR0 (Control device 24 bit DTR) to the required value, as well as DTR1 as the led index (if this is a multi LED product) and then send 0xBE0310 where 0xBE is the prefix, 0x3 is address 1 in dali address format and 0x10 is the opcode for SET_DTR0_AS_PRIMARY_TARGET.
Each switch can have 7 profiles worth of LED tracking. The profile must be changed into to configure, so the user would send 0xBE0321 (or 0xBEFF21 to send all devices into the profile).
The following LED Modes are available on Zen Switches. There is a wider range of led modes available to the user, using a zencontrol Control System.
|Comms Status||0||Flashes when button pressed|
|Inverted Comms Status||1||Always on, turns off when pressed|
|Target Status||2||Is on if target is on (must be direct commands to target to know)|
|Inverted Target Status||3||Is off if target is on|
|Scene Match||4||Set LISTEN SCENE to value. If last light command was scene will turn on, otherwise off|
|Scene Doesn't Match||5||As above but will be on if scene was not last lighting command|
|Always On||10||Remains On|
|Always Off||12||Remains Off|
|SET_DTR0_AS_PRIMARY_TARGET||0x10||Must use dali address format shifted 1 to the right, ie 0x81 is normally group 0, must use 0x40. 0xFF -> 0x7F.|
|SET_DTR0_AS_LISTEN_SCENE||0x11||0-15 for scene|
|SET_DTR0_AS_LED_MODE||0x12||See List of led modes above|
|SET_DTR0_AS_POWER_ON_MODE||0x13||Power on LED mode.|
|SET_DTR0_AS_OVERRIDE||0x14||Set to 1 to force on, 0 to force off. Useful for manual control|